Remodel/Wall removal questions

Meekrab

Meekrab

Trakanon Raider
16
1
Looking to open up the wall between our kitchen and front dining room area. Obviously at some point where the large opening is there used to be a wall and then there was a doorway going into the room that they closed in. I want to open up the whole span (as much as possible anyways), which is slightly over 12 feet from wall to wall.

What size beam would I need to run across the span? Could I do some sort of combination of wood & steel to make the beam smaller/not hang down as much?

go6GAcv.jpg


7PiSUJw.jpg
 
Julian The Apostate

Julian The Apostate

Vyemm Raider
2,440
2,528
“Entire family wiped out after homeowner takes structural load bearing advice from internet message board.”
 
  • 1Like
  • 1Worf
Reactions: 1 users
BrutulTM

BrutulTM

Good, bad, I'm the guy with the gun.
<Silver Donator>
15,128
-996
Talk to your local lumberyard (not Home Depot/Lowes). They usually have software to figure that sort of thing out. That said, assuming it's a weight bearing wall, that might be a job that would be worth paying a contractor to do just for the peace of mind that you haven't made your house unsafe.
 
You must log in or register to reply here.