i know, they are great, i am buying a pair to wear as slippers, soft comfy and WARM...which brand did you choose? or did you get generic
the 2020 line of bows are coming out now and some brands have some major revisions coming to their lines.
prime archery, their bows are getting the module adjustment setup now instead of having to use a bow press, undo a few screws rotate the module to the correct settings and all set, draw length adjustment from 25 1/2" to 31 in half inch increments and let off % from 65 to 90% with the cable stops being adjustable so that a person with a preferred draw length of like 29 3/4" can ajust the main adjustment to 29 1/2" or 30" and then adjust the cable stops the 1/4" needed.
PSE- just a few refinements, nothing major in revisions to their cam tech or bows
Bowtech - their "dead lock" cam tech and the rotating mods are going on more bows. the dead lock is..cam lean is adjustable with just an allen wrench on both sides no more having to use a bow press, removing the cable from cam, twist cable, replace on cam, undo press, checking timing/lean, rinse repeat until done., it is now for those bows. losen cam lock use wrench on the cam to adjust left or right, tighten lock, check to see if fixed, then done or adjust more.
for bow tuning/fixing what do you all have i made a few things plus the bowmaster g2 portable bow press and now i have a draw board, an arrow length cutter and a homemade bow stand.
draw board, - half inch iron pipe -wrapped in silicon to make it non marring attached to a 2x10 with a yard stick screwed on (i was off placing the yard stick by an inch on length measuring) with a cheap car winch attached at the end of the board, and a draw scale attached to the hook cost maybe 30 bucks to make (except for the scale that was 40 bucks).
the bow press i am using the bowmaster g2, with the ultimate limb brackets (i also have the brackets that are sold by bow master, but the ultimate limb bracket is significantly BETTER)-if you look the ultimate limb bracket up on amazon the pictured bracket is NOT what you get, it is now black and more refined but the basic shape is the same. this bracket will fit basically any bow and the little stubs on the inside that go in fit PERFECTLY into the end bracket/whatever they are called on mathews bows(without the plastic cap on the stubs) i have changed the bow string on both my bows with it and it worked great.
to hold the bow while using the bowmaster i am using a jig i made of 2 2x10 pieces with 2 2x4 sides holding it all in place, with carpet lined slots in the 2x10's that will hold the bow in firmly.